Where the wand meets the vacuum body on a stick vacuum.
It’s also impossible to remove the V6 battery when it’s plugged in.. Once the vacuum has been unplugged, prepare your V6 for a battery change with the following three steps:.Detach the wand to make the vacuum easier to hold..
Empty the dust canister using the red latch..Remove the dust canister by pressing the red latch another time.. One of the screws holding the battery in place is located at the front of the battery, so you need to remove the bin to access it.. Related Article:.How to Empty The Dyson V6.
Step 2: Remove Two Screws And The Old Battery.The Dyson V6 battery is secured using two screws.
These both need to be removed before you can take out the old battery.. Start by using a Philips screwdriver to remove the screw at the back of the handle.
Once that’s removed, turn the vacuum cleaner onto its side and remove the screw at the front edge of the main body of the battery.. It’s important to note that you should.A broomstick can get rid of larger clogs, but it can’t remove dirt that’s built up in the hose folds.
These folds are also very difficult to clean with a regular cloth..If your hose needs a deep clean, here’s a simple method:.
Fill up your sink with warm water (not boiling).. Add a small amount of washing-up liquid and mix it into the water.. Submerge the hose in the sink, allowing the water to seep into every internal crack and fold.. Move the hose around to agitate dirt and grime.Allow time for the water to loosen the dirt..