Use the spray bottle’s cleaning pad to wipe the blade before using it to clean the window.. Avoid cleaning windows when there is direct sunlight or in hot weather.
Start by placing the new belt around the motor shaft, then thread the brush roll through the belt.. You’ll then need to reinstall the brushroll back into its original location.For flat or round belts, the tension required may require you to use a screwdriver to pry the end of the belt into the correct position..
Your New Belt Will (Probably) Look Too Small.Depending on the type of belt your vacuum uses, the new one may look or feel too small.This is partly because the old belt will have stretched during use, but also because many vacuum belts are held in place through tension..
Even so, it’s a good idea to double check that the belt is the correct part for your vacuum’s model if you’re not sure that it fits.. Stretching is most common on flat or round vacuum belts.It’s less common on other types, such as geared (cogged) belts..
Step 5: Replace the Base Plate.
Once the brushroll is fitted, double check that everything looks correct by comparing it with the photos you took earlier.This is often due to a blockage in the floorhead or tangles around the brush roll..
Flashing red light.– This usually means that the motor has overheated causing suction to shut off.. No light.
– The brush roll is not turning as the vacuum is switched off.May also indicate an unknown error.. Green Light: The Brush is Working Correctly.