Up to 10 minutes run time with a 4 hour charge time.
If possible, use a vacuum with a rotating brush bar to pull up more hair and dirt.. Gently use the rake on your carpet by pulling in one direction, but be careful not to press too hard to push the rake too deep into the fibres.The rake should glide smoothly – if it’s not, then you’re pressing too hard.. Now use the rake in both directions, moving forward and backwards.
This step helps to fluff up the carpet fibres.. Give your carpet another thorough vacuum to remove any dirt, hair, and dust that’s been agitated during raking..Finish by raking in a single direction (pulling towards you) to give your carpet that “new” appearance..: Don’t use a carpet rake on a woven or Berber carpet.
The rake may pull out or damage the fibres..Method 3: Clean Dirty Patches of Carpet With White Vinegar.
White vinegar is a. useful tool for cleaning carpets.
, as it’s cheap and easily available..In the CH950UKT manual, Shark specifically mentions that you shouldn’t use a hair dryer (or any other drying tool) to speed up the process.
The filters should only be air-dried..Step 5: Re-Assemble The CH950UKT.
Once the filters are dry, you can put them back into the filter frame.The foam filter should go first, followed by the thinner felt filter..